This is for all those people rocking eyefinity setups now always going into 3d Mode.

I was pulling my hair out today after receiving my Sapphire 5850 in the mail. At stock with a clean install I was getting the annoying flicker issue. I run 2 HP LP2475w monitors, and I now see this flicker issue is very well known.

I figured I would just attach the bios I edited to make this all go away. And anyone can just edit my unlocked Asus bios in RBE themselves if they want to over/underclock the card and immediately get rid of the flicker issue without messing around with CCC Profiles or MSI Afterburner.

So it’s basically in 2d mode 400/1200 at 1.0875 volts and in 3D it’s set at 850/1200 at 1.0875 volts. I think the key to the flicker is the voltage in the x18 register in the GPU voltage editor.

Download